Step 1

Measure the window and cut the film to size with 2cm excess all round.

Step 2

Clean glass thoroughly with a few drops of baby shampoo in a spray bottle of filtered or bottled water.
Do not use vinegar or ammonia solution.

Step 3

Use two pieces of adhesive tape at top corner to start separation of the backing from the film.

Step 4

Spray the glass liberally with same baby shampoo/water mix as used to clean glass in step 1.

Step 5

Liberally spray the adhesive side of the film with the same solution as used in step 1 whilst peeling off
the backing.

Step 6

Starting at the top, place the wet adhesive side of the film onto the wet glass and work down the window.

Step 7

Squeegee any bubbles to within 2cm of the window edge. keep the film surface wet to allow the squeegee to pull easily across it.

Step 8

Use a utility knife to trim the film leaving a 2mm border between the edge of the film and the window.

Step 9

Re-spray the surface of the film and squeegee out any bubbles to escape through the gap between the film and the edge of the window.

 HINTS

• Before laminating make sure glass surface is very clean, free of dirt and dust particles. Use a lint free cleaning cloth.
• Don't leave dry spots on film before laminating.
• Don't press so hard on the squeegee that you stretch the film.
• Water bubbles (not air bubbles) still remaining after squeegee will usually evaporate within 2-3 days.
• For stubborn water or air bubbles prick the film with a small sharp pin and squeegee again pressing the film against the glass to facilitate adhesion.
• To maintain film surface do not use vinegar or strong detergents.

IMPORTANT

Do not apply the film to warm glass or when temperature is less than 5 degrees C or more than 35 degrees C.
Do not apply to non-smooth glass.